U boot manual5/21/2023 ![]() ![]() Has any one previously use SPI from u-boot to access SPI slave?Īny suggestion or pointers would be appreciated.Īs we have produce demo on 12th April 2016 this is bit crucial for us. I would appreciate if anyone can suggest any other reference code that we can use. Manually connect the consoles telnet port. Ende des Ladekabels in den Steckplatz (Abb. I managed to do a Petalinux 2017.2 build but now, to get a sense of. Here I have two concerns why it is showing 0x30 even though I write 3 only.ĭoesn't matter whatever I write it always shows timeout error.Ĭan we use this utility as reference to read/write spi eeprom? Test the target boots and U-Boot runs and obtains a valid DHCP lease. Entnehmen Sie die Schalter-Stecker-Einheit vom U-Boot und stecken Sie das andere. Hi there, Im working at this moment on a manual build for an SD card booting Linux. Spi_xchg_single: bitlen 8 dout 0x8ffa5044 din 0x8ffa5064 ![]() I tried to to access it using "sspi" command on u-boot but didn't succeed. Now we want to use same SPI EEPROM from u-boot level. We are able to operate SPI EEPROM from kernel space. Introduction to U-BootBuilding U-BootTesting U-Boot with QEMUU-Boot and physical boardsU-Boot and mkimageLoading images from storageLoading images over netwo. Thes eimages can contain the linux kernel, device tree blob, root file. In our board we have SPI EEPORM (Part number :25AA010A). The mkimage command is used to create images for use with the U-Boot boot loader. We are using im圆q based customize board for our product. ![]()
0 Comments
Leave a Reply. |